1 Are there default values for each motor type ?

2 How is the serial communication to the MAC motors ?

3 Is it possible to communicate through Hyperterminal ?

4 Why do you call it an AC Brushless motor and not a DC Brushless ?

5 What is O1 used for ?

 

6 What is O2 used for ?

7 What is "Function error" ?

8 Which input is used for "Zero search " ?

9 What is the "Home Position” ?

10 How does Torque Homing work ?

 

11 How do I setup the Filter Parameters and what is the Load Factor ?

12 Which values for Load factor can be used with success ?

13 In which register can I find the Actual Torque ?

14 What is "In Position Window" and "In Position Counts" ?

15 To which of the 8 available position registers do the "In Position Windows” apply?

 

16 There are 4 accelerations, 4 torques, 4 Load Factors. How are they applied to 8 position registers ?

17 Is Autotuning available ?

18 Test tab runs incremental and not absolute as expected ?

19 How do I update the firmware in the motor and module ?

20 How do I stop the MAC motor in the middle of a move ?

 

21 How do I run to absolute or relative positions ?

22 What does "Resyncronize position after passive mode" mean and do?

23 What communication speed is possible?

24 How is Velocity and Acceleration scaled?