More Information DMC10
|
For controlling DC servo motors
This Controller can be used for controlling DC motors up to 1kW and is characterised by its flexible application and control features. The Controller can either be controlled directly via the built-in RS232C interface, or indirectly using 4 digital inputs. These refer to 16 user-defined positional and speed references which are read into the Controller´s registers via the RS232C interface. The DMC10 Controller can also be driven using an analog input of +/-10V. In addition, the Controller can be used as a step motor system with step-pulse and directional signals. 4 general purpose outputs can be configured to provide signals when the motor has reached a desired position, for example, or to provide error signals if a condition that prevents motor operation occurs. |
The DMC10 is easy to program using JVL´s windows-based software, MotoWare. For example, various speed profiles can be set by defining acceleration, deceleration and speed. The Driver is also equipped with a built-in programmable end-of-travel and a zero-point seek function. As input from a feedback sensor to the Controller''s digital regulation loop, the DMC10 accepts both a balanced and unbalanced signal, e.g. from a standard 2-channel incremental encoder. All inputs and outputs are optically isolated and overload protected to provide high immunity to spurious noise signals. Similarly the Controller is both temperature and short-circuit protected. The entire Controller construction has been designed to afford the best possible compliance with EMC requirements. The Controller cabinet fits into a 19" rack but can also be surface mounted. |
JVL A/S Bregnerødvej 127 DK-3460 Birkerød Denmark
Tel: +45 4582 4440 Fax: +45 4582 5550 E-mail: jvl@jvl.dk
Tel: +45 4582 4440 Fax: +45 4582 5550 E-mail: jvl@jvl.dk
