MIS171-MIS176 ServoStep - NEMA17 Programmable Integrated ServoStep Motors with Closed-Loop, Ethernet, multiturn encoder

MIS17xS Dimensions

(download)

MIS17xQ Dimensions

(download)

• PLC/RS485
• CANopen
• SSI enc.
• Profibus
• Ethernet

Choose between wireless Bluetooth, WLAN or Industrial Ethernet Profinet, Ethernet/IP, EtherCAT, Powerlink, MODBUS TCP/IP, SERCOS III, RS485 and PLC built-in are standard. 8IOA, SSI and pulse/direction

Industrial Ethernet	Profinet, Ethernet/IP, EtherCAT, Powerlink, MODBUS TCP/IP, SERCOS III . Built in dual port Ethernet switch for simple wiring and cost reduction.	Read more
SSI (RS485)	Build in SSI interface for external incremental or absolute encoder. 5V balanced signals.	Read more
CANBUS	CANbus DS-301 with heartbeat/Node guarding/sync etc.	Read more
MODBUS (RS485)	RS485 interface for serial 2Mbit daisy chain communication for low cost solution.	Read more
MACTALK (RS485)	RS485 interface for live diagnostics, setup and user programming.	Read more
PLC	8 input/output/analogue input allow highly advanced functions via the build in PLC.	Read more
Gear Mode (RS422)	In this mode the ServoStep motor functions as in a step motor driver. The motor moves one step each time a voltage pulse is applied to the step-pulse input. Velocity, acceleration and deceleration are determined by the external frequency, but can be limited and controlled by the ServoStep motor. In addition, the ServoStep motor also provides a facility for electronic gearing at a keyed-in ratio.
Serial Mode (RS485)	In this mode the ServoStep motor’s registers contain the positions, velocities, accelerations, etc., required for the actual system. The registers can be selected and executed by a single byte sent via the serial interface. This mode provides maximum utilization of the ServoStep motor’s features since the ServoStep motor itself takes care of the entire positioning sequence.
Position and velocity Mode (RS485)	With command sent over the serial interface can position and velocity be changed. Various operating parameters can be changed continuously while the motor is running. This mode of operation is used primarily in systems where the Controller is permanently connected to a PC/PLC via the interface. It is also well suited for setting up and testing. The mode is also used when programming is made.
Outputs	Up to 8 pcs high side for relay, PLC or brake control. 24VDC PNP high power 0,4A (peak 0,9A) each. Short circuit and reverse protected.
Inputs	Up to 8 pcs 24VDC logic inputs that can we used for limit switch, homing, position capture, enable input, pulse/dir.
Analogue input	Up to 8 pcs 0-5V 12bit that can we used in program for analogue to speed or position. Protected up to +-30VDC.
RS422	Input used for connection of external encoder, AB incremental signal or pulse and direction signal. 5VDC balanced signal A+.A-,B+.B-

MIS171 Torque/Power vs. Speed		MIS173 Torque/Power vs. Speed
(download)		(download)

MIS176 Torque/Power vs. Speed
(download)

Go to JVL Youtube Channel
JVL Presentation Video
JVL Academy
MIS17-43 Connection guide
How to connect and test a JVL integrated motor
Closed loop linear movement
Closed loop rotation torque
IO-Link for JVL motors